HPFP Hub Puller replacing VW tool T40064
Puller for the Bosch CP4 high pressure fuel pump drive hub on 2009 – 2014 VW common rail TDIs. If you're swapping the high pressure pump on one of these engines you need this tool to remove the hub so it'll pass through the accessory bracket. The two legs thread into the hub and the center forcing screw presses the hub off the pump shaft. Use our HPFP holding wrench <LINK> for the 3 M10 sprocket bolts and the 3-Pin Tri-Spanner Counterhold Tool <LINK> to facilitate removing the center shaft nut.
- Not required for timing belt service
- Replaces VW/Audi tool T40064
- Required for high pressure pump replacement on 2009–2014 TDIs, including the CJAA, CBEA and CKRA (EA189 common rail)
- Does not fit the 2015 year model TDI with CRUA and CVCA (EA288), these use a different pump hub.
- Manufactured in Taiwan by HCB